Hungaroring tech file

The Hungaroring offers plenty of challenges to drivers and engineers alike. The circuit features no high-speed corners, leading the teams to run the highest possible downforce levels, while the primary concern for the engine teams is ensuring good cooling in the usually hot conditions. The high summer temperatures also make life difficult for the drivers, who need to be in peak physical condition to cope with a race that gives them very little respite over its 70-lap distance.

Chassis

The twisting, 14-corner layout of the Hungaroring features just one legitimate overtaking opportunity per lap, into turn 1. Apart from this straight of just over 700m, the circuit is filled with sequences of low to medium-speed corners, with short braking distances which make overtaking nearly impossible. The result is that the teams all run with maximum downforce levels, similar if not identical to those used in Monaco, in order to optimise not just cornering speeds but also braking and traction. Maximum speeds achieved on the main straight rarely exceed 300 kph with the V8 engines.

Mechanical grip is an important factor at a slow-speed circuit such as this, and teams will generally try to run the car with softer settings all round to improve mechanical grip. The drivers want a responsive car in the slow-speed sections, with good traction on corner exit, which will usually lead the teams to a forward mechanical bias (stiffer front/softer rear) in terms of set-up. However, rear tyre wear must be monitored very carefully, particularly to avoid overloading the softer compound available this weekend.

Bridgestone will make available the Soft and Super Soft compounds from its 2007 range, as were used in Monaco and Canada. The low-grip circuit conditions, coupled with the absence of high-speed corners, make these choices possible. As has become customary, the tyre management challenge for the weekend will be to control graining on the softest compound, and this should improve as the circuit rubbers-in throughout the weekend. Data collected during practice will determine whether the super-soft is suitable for use during the majority of the race, while cooler-than-expected temperatures, or overnight rain washing the circuit clean of rubber, could further complicate the situation.

The other important chassis parameter will be ensuring good cooling of the mechanical parts. Although the car’s cooling capacity is now well-known, attention must be paid to ensuring the radiators are still well-cooled in spite of the high levels of front downforce we run at this circuit. This will have been the object of particular attention in the wind tunnel, and will be fine-tuned during the weekend to ensure the cooling solution required brings the minimum performance penalty.

Engine

With the longest period spent at full throttle barely exceeding ten seconds, and with only 57% of the lap spent at full throttle (significantly lower than the average), this is not a demanding circuit for the engine. Of the 14 corners, five are taken in second gear at around 100 kph. Unlike at Monaco, where the cars reach abnormally slow speeds in the hairpins, the minimum speed at the Hungaroring is approximately 90kph. This means the engine spends the majority of its time in a relatively narrow operating window between 100 kph and 250 kph, and the closely-spaced gear ratios we use are selected to ensure optimum performance in this range. As always on a circuit featuring a large number of slow corners, good torque is important to help launch the cars out of the turns. The characteristics of the RS27 mean the engine is strong in this area.