Scuderia AlphaTauri AT03 Speculation Thread

[RZS10]

The RW kinda looks like it is just taken from the FOM model (?) +DRS & gurney


quick n dirty side by side with the FOM render from last year

[AeroDynamic]

Higher Res + Brightened Top View Details

[Giando]

Not clear to understand, the air flux inside the lateral sidepod, where it goes? maybe there is hole
down back in the floor and goes in the diffure exit? I think is forbiddens, so where it goes?

It goes up inside and around the engine to blow out from the upper exit in front of the beam wing, like Redbull 2012-13... sidepods also reminds me those of that era, too

[AeroDynamic]

Good Res Renders






Details Enhanced

[wogx]

We are comparing MCL36 to AT03.

There is a thread for it.

2022 car comparison thread
viewtopic.php?t=30227

[PlatinumZealot]

And extremely high driveshaft and rear bottom wishbones They are very close to the top ones...

I think the 3D artist messed up that part of the model. If not, that is a serious structural disaster waiting to happen!

I have seen conecept cars and the like with two wish-bones above the centre of the wheel, but not a real car. It loads the upper A-arm in compression and the lower one in tension and Vice-versa. So You can imagine the amount of shear and overall force concentration in the wheel upright would be crazy. haha.

The correct wish-bones are shown here I think**:

[RZS10]

At least we won't have to argue whether the sidepods are hollow on this one ...

[Pandamasque]

That's another car with very large front brake ducts.

[Zynerji]

Good looking car!

Disappointed that AT doesn't have white wheel spats.

I would say that this looks very bespoke as well. I was concerned that the 2022 regs would make the cars mostly identical. I'm very glad to see such diversity in concept with such prescriptive rules.

[nzjrs]

A good way to attract air and accelerate it towards diffuser top and beam wing
https://i.servimg.com/u/f87/14/79/55/26/fljwx311.jpg

I think is the most? different thing on theses renders compared with the other 'launches' so far.

[F1Krof]

This looks interesting. Three major over-channels.





P.s. I also don't believe the nose and the front-wing is the real one.

[RZS10]

Disappointed that AT doesn't have white wheel spats.

Wouldn't look that great though ... https://i.imgur.com/rGAxzEr.png

[Zynerji]

Disappointed that AT doesn't have white wheel spats.

Wouldn't look that great though ... https://i.imgur.com/rGAxzEr.png

YESSSSSS!

Or "Rising Sun" red with a white border!

[Owen.C93]

I wouldn't fully agree with saying it's a low nose. Maybe a middle ground.

[Zynerji]

I wouldn't fully agree with saying it's a low nose. Maybe a middle ground.

https://i.imgur.com/D3iNBgu.png

All wings look Monza Spec this year!