RacingManiac wrote:Seems risky, but I assume they have run this before(though the fact that the cars don't have this at the same time from the get go seems to say otherwise).
George Howard-Chappell declared to Endurance-Info that they have run it succesfully in a test at Portimão and that its benefits concern more increased mileage than engine power. On a side note, Oreca's boss Hughes de Chaunac manifested its disapproval of this system being allowed to be run, not being used in GT. Let's recall Aston-Martin benefits from larger restritors than competitors with racing engines, because their engine is homologated in GT1. De Chaunac said something like Le Mans being like a world cup of football with referees from the Junior League.
Audi R15
Sebring/Le Mans comparison photos by SpeedTV's Marshall Pruett:
Rear wheel air exit
Air extraction from engine bay (change mandated by the ACO)
Scrutineering photos by Laurent Chauveau for Endurance-Info:
New turbo scoops, as required by the Audi's powertrain engineers
New wing endplates
New lateral front wheel bay air exit
New blanking plates (or downforce-generating wings, as per Peugeot's protest) masking the lower front wishbones, replacing the legality mesh that was previously used and that, with dirt accumulation made the aero balance of the Audi shift as the race progressed (the two elements visible above the Michelin logo)
Peugeot 908
According to Endurance-Info, the Peugeots will benefit from lower drag from the new front (that also shiftes the aero balance rearwards to compensate the new rear wing) and, despite the reduction in the restritor's diameter, more power than last year, what could mean better lap times than in 2008.
Photo credits to Laurent Chaveau/Endurance-Info
Close up of the flow diverter under the raised nose (notice how the lateral bulge a bit back on the side of the nose now seems to mess with the airflow)
Lola B06/80-"Aston Martin DBR2/1"
Photo credits to Laurent Chaveau/Endurance-Info
New lateral filling plate between the headlights and the wheel, just like used extensively in the last few years in all Lolas. Notice that the amount of the very drag-penalizing louvers hasn't been apparently reduced, unlike most competitors do.
Oreca 01-AIM
Photo credits to Laurent Chaveau/Endurance-Info
Newly shaped legality plates linking the front fenders to the chassis (carbon black part)
Pescarolo LMP1
Photo credits to Laurent Chaveau/Endurance-Info
New lower engine cover
Now, it's almost time to see this babies in action in the first practice session!