747heavy wrote:speedsense wrote:
IMHO, The rear most "round" bar is the toe link on the Peugeot.
And in the same Long plane as the arm.
Think about the two Mclaren lengths, adjust one longer, the other one would resist the lengthening of it as there isn't a pivot point between the two. You would have to change both lengths to change toe.
As far as why it's that way (double arms)...can't say, never seen anything like it...
agree with the first assessment
not quite sure if I understand the "Long plane" discription of yours - appologize,
as to me it(the Peugeot toe-link) is not in the same longitunal plane on the upright)
even if the two links are parallel in this photo/perspective (in others they are not allways), I would not imply that they join the upright in the same "plane".
see in this perspective, the two links are not parallel, indicating to me, that the lower one is running forward and therefore optical closing the gap in this perspective.
to me (but I could be wrong) the lower wishbone is facing/heading forward (towards the upright) to join underneath the driveshaft while the "toe-link" joins behind the driveshaft.
very similar to the Peugeot position or older Renault F1 rear suspension layouts.
Therefore, I can´t see the problem with lengthing only the toe-link to get a change in toe.
A trulely parallel second link (double arm) (joining at the same plane onto the upright and chassis) would over constrain the suspension - IMHO (similar to a driveshaft without float), so how this should work !?!
Sorry at least to me, that does not look like anything special or out of the ordinary.
They run the "toe-link" parallel to the lower wisbone, while ohers run it parallel (or in plane - Williams Z-wisbone) to the upper.
I did not find a very good shot where the wisbones joint the upright so I guess we have to wait for a while, but to me this looks like what I try to explain above.
hi res photo can be found
here
in principle this (at least to me) looks similar to
this or
this
note (in the first photo) that lower wisbone and "toe-link" look parallel in this photo as well, but dont joint the upright in the same plane.
Let´s wait and see, sooner or later there will be some more detailed photos from the upright or rear suspension.