PrancingBull wrote:Excuse the ignorance here, but could someone point out exactly which shapes on the photo are the exhaust outlets. I think I'm struggling with depth perception on this shot too, so it's hard to see what's blowing what!
Cheers
PrancingBull wrote:Excuse the ignorance here, but could someone point out exactly which shapes on the photo are the exhaust outlets. I think I'm struggling with depth perception on this shot too, so it's hard to see what's blowing what!
Cheers
It's not often a post on F1T has me giggling =D>gibells wrote:I see your asymmetrigate and raise you an illusiogate.ianwit wrote:That's been done to comply with the F1t asymmetry requirementsJB2011 wrote:One pipe is lower than the other - maybe it was more rushed than we thought!
PrancingBull wrote:Excuse the ignorance here, but could someone point out exactly which shapes on the photo are the exhaust outlets. I think I'm struggling with depth perception on this shot too, so it's hard to see what's blowing what!
Cheers
I agree!feynman wrote:As a huge fan of the white exhaust pipes from the late 60s, I for one approve very much of this diffuser. All cars look better with something white and heat-resistant bolted near the back. It's a rule.
Of side-interest: Seeing this new diffuser has only two vanes, one either side and out wide, it does look quite a lot like the left hand side of the 'half-and-half' floor that was argued about pages ago - that whole optical-illusion versus McLaren mixed-mode combination testing, anyone possibly thinking about switching horses?
feynman wrote:As a huge fan of the white exhaust pipes from the late 60s, I for one approve very much of this diffuser. All cars look better with something white and heat-resistant bolted near the back. It's a rule.
Of side-interest: Seeing this new diffuser has only two vanes, one either side and out wide, it does look quite a lot like the left hand side of the 'half-and-half' floor that was argued about pages ago - that whole optical-illusion versus McLaren mixed-mode combination testing, anyone possibly thinking about switching horses?
i think you're seeing thingsJB2011 wrote:One pipe is lower than the other - maybe it was more rushed than we thought!
I'm not too sure why you think this is a good thing for McLaren. With the relatively stable set of regulations we've had since 2009 all you're saying there is that McLaren are effectively two years behind their rivals in a lot of areas.myurr wrote:The McLaren is a brand new design that has more scope for fine tuning as the team learns what works and what doesn't, and how to get the best from it.....Red Bull and Ferrari are evolutions of well known concepts.....
If that is the case then if they're two years behind but on similar pace then they will definitely find it easier to bring pace to the car.segedunum wrote:I'm not too sure why you think this is a good thing for McLaren. With the relatively stable set of regulations we've had since 2009 all you're saying there is that McLaren are effectively two years behind their rivals in a lot of areas.myurr wrote:The McLaren is a brand new design that has more scope for fine tuning as the team learns what works and what doesn't, and how to get the best from it.....Red Bull and Ferrari are evolutions of well known concepts.....
I agree richard. The'll attract a curse if they keep on offending those rule spirits. Making your cooling aids out of heat resistant material looks like mocking the rules!richard_leeds wrote:According to the rules, those U channels feed air to that brake duct, while the hot exhaust is tucked underneath the brake duct to avoid over heating the brakes..... some say those brake ducts generate downforce and are coupled with the diffuser + beam wing. Perish the thought - that would be outside the spirit of the rules!