Ferrari F2012

[medeni73]

[quote="amouzouris"]the old metal part was probably fixed on the bodywork...


Thanx for info, it seems no changes then...

[amouzouris]

no actually there is a change...look at the first photo i posted and the last of the new exhaust...it is different!

[Nando]

Exhaust channel has been moved slightly inwards from what i can see. or the cooling hole next to it has been widened.

[alogoc]

Exhaust channel has been moved slightly inwards from what i can see.


[img]http://www.sutton-images.com/previews/d12hun22.jpg[img]
[img]http://p.twimg.com/AvQheJrCQAACNC2.jpg:large[img]

i was thinking the same! but maybe the angle!

[medeni73]

You're maybe right cos on photos with "naked" exhaust it seems that the end of new one (with metal plate on it) points more inwards...But then again it could be just an angle...

[Nando]

Easier to see in this picture, clearly not the same housing.

[enz0]

Just wondering, could they be trying to clean up the coke bottle area down the rear by pointing the exhaust inward?

[Owen.C93]

That metal part just wasn't fitted in the "old" picture you posted. Nothing new there.

[amouzouris]

That metal part just wasn't fitted in the "old" picture you posted. Nothing new there.

the "metal part" is different though in the picture i posted...

[medeni73]

It is very difficult to see because of various angles... Its obvious that the gap between cooling and exhaust holes has become extreme smaller because:
- cooling hole got wider
- or exhaust channel points more inwards...

[Owen.C93]

That metal part just wasn't fitted in the "old" picture you posted. Nothing new there.

the "metal part" is different though in the picture i posted...

Looks the same but you may be right. You can see the fitting on the old exhaust so it would always have been attached to it though.

[Nando]

That metal part just wasn't fitted in the "old" picture you posted. Nothing new there.

Look at the yellow highlighted area. There´s no metal there and there should be no metal there.

It´s crystal clear it´s a new housing. the question is what has changed, housing or intake.

[alogoc]

That metal part just wasn't fitted in the "old" picture you posted. Nothing new there.

Look at the yellow highlighted area. There´s no metal there and there should be no metal there.

It´s crystal clear it´s a new housing. the question is what has changed, housing or intake.

they are talking about metal part just above exhaust pipe end that creates low pressure pushing exhaust gas down!
not the exhaust housing you highlighted!

[Nando]

That metal part just wasn't fitted in the "old" picture you posted. Nothing new there.

Look at the yellow highlighted area. There´s no metal there and there should be no metal there.

It´s crystal clear it´s a new housing. the question is what has changed, housing or intake.

they are talking about metal part just above exhaust pipe end that creates low pressure pushing exhaust gas down!
not the exhaust housing you highlighted!

oh ok my bad, thought he replied to my picture.

[alogoc]