Because the tip is still lower, so the impact point stays the same. Plus the cover will be design to not harm the driver.
http://scarbsf1.com/blog1/2012/10/01/20 ... n-changes/
Thanks Lurk, it makes a lot more sense to me nowLurk wrote:Because the tip is still lower, so the impact point stays the same. Plus the cover will be design to not harm the driver.
http://scarbsf1.com/blog1/2012/10/01/20 ... n-changes/
3.7.9 wrote:With the exception of an optional, single piece, non-structural fairing of prescribed laminate (whose precise lay-up may be found in the Appendix to the regulations) which may not be more than 625mm above the reference plane at any point, no bodywork situated more than 1950mm forward of rear face of the cockpit entry template may be more than 550mm above the reference plane.
good points, it is not nessesary and could get things complicated, all in all big joke only to please the eyes of they grey mass that probably has no taste at all. This may sound arrogant but the looks of F1 are not related to road cars and they don't have to look in a certain way other than the rules allow, they just have to be F1 cars designed to get the most out of the regs.raymondu999 wrote:So here's me wearing my conspiracy cap. How about parc ferme? I suspect having the panel on will be fixed as per parc ferme regs - but could you then bring alternate noses to weekends? Have a low-drag modesty-panel for Monza, and have maybe some higher downforce solution for Monaco.
Also, what of changing front wings? Would you be allowed, in an in-race pitstop, to switch between a panel-covered and non-covered step nose? Or if... you know... one of the latchings fails and the panel falls off in the race, while being there in quali.
You called itWhiteBlue wrote:Modesty panel will be a one season solution anyway. From 2014 the noses will come down to 185 mm from 550 mm now and then the high nose design will be history, unless they change it last minute of course.
The CoG penalty will be far less then the 2011 noses. If I am correct they can make the panel as thin as they want, reducing the very small disadvantage even further. And any disadvantage will be offset by the better flow over the nose, which was quite a concern.bhallg2k wrote:It's my understanding that the rules essentially revert nose cones back to pre-2012 form, but with added caveats that the crash structure within them must adhere to 2012 standards, and any bodywork above the crash structure must be comprised only of a very thin laminate (the material for which might even be specified). Otherwise, it's all business as usual. It will factor into a car's weight, and it will come with a CoG penalty, albeit a miniscule one.