(This is my first post so go easy on me.) I had always wondered why in all other forms of motor sports drafting is a huge advantage but in formula 1 "dirty air" is much larger concern. After reading through this thread, http://www.f1technical.net/forum/viewto ... f=3&t=1206, I think I can summarize the issue roughly as follows (challenge this if it is wrong)...
* A trailing F1 car does gain an advantage on the straights from overall drag reduction from drafting yielding increased top end speed.
*In F1, were there are many corners (especially high speed corners), the advantage gained from drafting is more than offset by disadvantage of dirty air, which decreases downforce, thus lowering the speed a trailing driver can sustain in the corners.
This has been an issue for F1 because it tends to lead to runaway winners on track. Management's 'solution' has been DRS, which some object to because it gives a contrived advantage to trailing race cars (amongst other reasons).
How about this for an alternative to DRS? Instead of Drag Reduction System, F1 cars could have a Drag Increasing System (DIS) on the rear wing. Instead of trailing cars decreasing their drag in the straights by using DRS, they would increase their downforce in the corners using DIS. Since 'dirty air' affects trailing cars in the curves more than it affects lead cars in 'clean air', DIS would be a greater advantage to the trailing car, even if it were available to both cars.
Since a car with DIS enable would be safer (more downforce, slower in a straight), you could get rid of detection zones entirely.
Lastly, during qualifying DIS would be disabled entirely and the setup of a car's wing would be locked in for the race.
Thoughts?