I dont know whether this topic ever been discussed before... I've been search in the forum for 'asymmetric turbocharging', and find nothing
At first I want to write it on GPU thread & Alternative PU thread, but I think it is better to stand alone thread because it's not just about PU, but I more concerned about the noise
I thought it was my idea, but then I found this site
http://www.pistonheads.com/gassing/topi ... 6&t=287344
A bit different than Saab 9-5 3.0t asymmetric turbocharging system, my idea is using the opposite cylinders right in front of the gearbox to fed the turbocharger
The point is using some cylinders to fed the Turbo and the others are to produce noise. Off course it need to increase the rpm limiter, perhaps 18K (?)
So, there will be 5 exhaust pipes on the back, 2 are for wastegates
Is it possible to apply this on 2019 F1 car? I think it wont need a lot of development. Perhaps only some considerations about mechanical and thermal balances
Im not an engine guru, so I might be mistaken
*EDIT: some quote from pistonheads.com
" In an 'asymmetric' turbo installation, all cylinders are force fed through a single intake/plenum - but the 'hot' side of the turbo is driven by the exhaust gases of only one cylinder bank. This was used in the Saab 9-5 3.0t to provide a modest, but useful performance boost in the low/midrange rpm band with as simple a configuration as possible. Not only you can simply hang the turbo on the end of one exhaust manifold as per an in-line engine (in fact, in the Saab's case the exhaust turbine housing was integrated into the manifold) but as you're only using the exhaust gases of three cylinders to pump more air into six, the resulting boost pressure was low enough to remain unregulated - there's no wastegate on this one. "
Some links :
https://forums.anandtech.com/threads/wh ... v6.788612/
http://www.cardomain.com/ride/2962382/2001-saab-9-5/
http://raquettelaker2.blogspot.co.id/20 ... mages.html