there is still a burn mark thereMorteza wrote: ↑06 Mar 2018, 10:11They have added holes in this area they had the overheating problem
https://pbs.twimg.com/media/DXmBt--X0AAihy7.jpg
Via @crosaleny
They have also changed the bodywork (top is new)
https://pbs.twimg.com/media/DXmDzQLXcAAp2UD.jpg:large
Via @AlbertFabrega
Yes! As much as I want to stay optimistic about this, it just hasn't gone away. Doesn't look goodjagunx51 wrote: ↑06 Mar 2018, 12:20there is still a burn mark thereMorteza wrote: ↑06 Mar 2018, 10:11They have added holes in this area they had the overheating problem
https://pbs.twimg.com/media/DXmBt--X0AAihy7.jpg
Via @crosaleny
They have also changed the bodywork (top is new)
https://pbs.twimg.com/media/DXmDzQLXcAAp2UD.jpg:large
Via @AlbertFabrega
So the burn mark is from last week?
I believe its the same engine cover from last week
OR... perhaps the part is just too close to the bodywork, changing the bodywork will affect the aerodynamic of the carMorteza wrote: ↑06 Mar 2018, 12:22Yes! As much as I want to stay optimistic about this, it just hasn't gone away. Doesn't look goodjagunx51 wrote: ↑06 Mar 2018, 12:20Morteza wrote: ↑06 Mar 2018, 10:11They have added holes in this area they had the overheating problem
https://pbs.twimg.com/media/DXmBt--X0AAihy7.jpg
Via @crosaleny
They have also changed the bodywork (top is new)
https://pbs.twimg.com/media/DXmDzQLXcAAp2UD.jpg:large
Via @AlbertFabrega
there is still a burn mark there
SAME. ENGINE. COVER.
Definitely the same engine cover. The marks were visible when they started today.Sieper wrote: ↑06 Mar 2018, 12:49Could be, perhaps they didn't want to spent the time on making a new part/repainting it. But at the very least they have now added three slots to them. Why would you do that if the heat staining was caused by a malfunctioning tightener/screw (which will never happen again). They are making changes to this area, that we can see.