The pressures where for sure high at 27 psi. I've owned cars that had pressures lower than that.
The pressures where for sure high at 27 psi. I've owned cars that had pressures lower than that.
Of course it was about blistering, but the fact is that the Mercs were blistering after only a few laps. Whereas the RB was not blistering. So, either the geometry was at fault, putting unusual strain on the tyres, or else the drivers....both of them....were pushing the cars too hard. And as regards tyre pressures? All cars had to run with the same pressures.zibby43 wrote: ↑09 Aug 2020, 20:46
It's not a matter of over-driving. Or tire degradation. It was a matter of blistering today.
Blistering occurs when a tire overheats. The excess heat causes the tread to soften, and then it starts to break away.
What factors can cause overheating? Several, but 2 of the most important are: 1) over-inflation and 2) high track temperatures. The third factor is how much the car is asking from the tires, and the Merc demands a lot due to the downforce it generates, but it is a very well-sorted car on the suspension front, which is why, the vast majority of the time since '19, Merc has had class-leading tire wear.
I also don't think there is anything Mercedes could've done in qualifying to make themselves slower in qualifying, and subsequently faster in the race. Those setup choices and the trade off between race and quali pace are more relevant when it comes to degradation, not an anomaly like blistering.
Kind of like how Mercedes goes with a low rake concept to be well-rounded and fast at the majority of circuits on the calendar, they design the car/suspension to consistently energize/work with the harder compounds that are used on race day, in a temperature range that best represents most of the calendar.
For whatever reason, the Red Bull struggles to get the best out of their car in the circumstances that apply to the vast majority of races, but on those one-off days when the tires are pumped up to levels approaching the PSI of a 19" road car tire and the track temperatures are 40+ C, the car just suddenly works.
That's not the point, and I'm pretty sure you know that!
So you are saying that all other teams were able to plan for the higher tyre pressuresa but merc were not able to? There is no evidence that tyre pressure itself was the problem. All teams had the same info.dans79 wrote: ↑09 Aug 2020, 21:22That's not the point, and I'm pretty sure you know that!
Every team designs their car to work within a given range of numerous factors including tire pressures. The tire pressures for this weekend were far hire than they normally are.
No one outside of Mercedes will know for sure what tire pressure range Mercedes designed their car for. However in my opinion they didn't do anything set up wise to negate the high pressures.
Absolutely. But as Hamilton pointed out during the race (which is amazing he could notice this visually while driving an F1 car at speed around Silverstone), it looked like the Red Bulls' in-race tire pressures were lower than the Mercs'.aral wrote: ↑09 Aug 2020, 21:10Of course it was about blistering, but the fact is that the Mercs were blistering after only a few laps. Whereas the RB was not blistering. So, either the geometry was at fault, putting unusual strain on the tyres, or else the drivers....both of them....were pushing the cars too hard. And as regards tyre pressures? All cars had to run with the same pressures.zibby43 wrote: ↑09 Aug 2020, 20:46
It's not a matter of over-driving. Or tire degradation. It was a matter of blistering today.
Blistering occurs when a tire overheats. The excess heat causes the tread to soften, and then it starts to break away.
What factors can cause overheating? Several, but 2 of the most important are: 1) over-inflation and 2) high track temperatures. The third factor is how much the car is asking from the tires, and the Merc demands a lot due to the downforce it generates, but it is a very well-sorted car on the suspension front, which is why, the vast majority of the time since '19, Merc has had class-leading tire wear.
I also don't think there is anything Mercedes could've done in qualifying to make themselves slower in qualifying, and subsequently faster in the race. Those setup choices and the trade off between race and quali pace are more relevant when it comes to degradation, not an anomaly like blistering.
Kind of like how Mercedes goes with a low rake concept to be well-rounded and fast at the majority of circuits on the calendar, they design the car/suspension to consistently energize/work with the harder compounds that are used on race day, in a temperature range that best represents most of the calendar.
For whatever reason, the Red Bull struggles to get the best out of their car in the circumstances that apply to the vast majority of races, but on those one-off days when the tires are pumped up to levels approaching the PSI of a 19" road car tire and the track temperatures are 40+ C, the car just suddenly works.
Note that apart from the inner edges of the fronts blistering, the rears were blistering in the centre
Red Bull didn't luck into the win. You have to build a car that is capable of capitalizing upon today's unique conditions, and then when those conditions arise, you have to execute. They did both.TimW wrote: ↑09 Aug 2020, 21:19I would have expected Mercedes to be the king of tyre management this year, with DAS giving them an additional control input. Bit surprised that there is no clear advantage.
Also a bit surprised that some above are 'blaming' the tyres for Mercedes loss today, as if Red Bull lucked into this win. Tyre management is and has always been a key factor in racing. Red Bull have been very good at it in recent years, and should be applauded for that.
How do you know? Mercedes doesn't operate with great margin for variables. Increase in tyre pressure probably wasn't part of their simulations which yielded them a race setup for this weekend. Their most optimum performance comes with that inability to accommodate the unexpected variable, which probably an acceptable compromise for them.aral wrote: ↑09 Aug 2020, 21:48So you are saying that all other teams were able to plan for the higher tyre pressuresa but merc were not able to? There is no evidence that tyre pressure itself was the problem. All teams had the same info.dans79 wrote: ↑09 Aug 2020, 21:22That's not the point, and I'm pretty sure you know that!
Every team designs their car to work within a given range of numerous factors including tire pressures. The tire pressures for this weekend were far hire than they normally are.
No one outside of Mercedes will know for sure what tire pressure range Mercedes designed their car for. However in my opinion they didn't do anything set up wise to negate the high pressures.
No one planned for them, every team has to decide during the design phase of their car what criteria they think they will be expected to race under during the season.
That's your opinion, and one that I think is wrong. Track an ambient temperature was higher than last week, The compounds were softer, and the tire pressures were substantially higher.
In past years when pirelli changed tire pressures regularly, they would examine the tires after FP1 and fp2, And then announce the changes Saturday morning before FP3.
It was announced on 5th of August, Wednesday.
It certainly did Stroll's WDC score some good, but I strongly suspect Hulk would've kept Albon behind. Team points sacrificed for driver points...