Modelling car body in solid works? Best way?

[rjsa]

http://www.tsplines.com/products/solidworks.html

This could be a nice try.

[flynfrog]

Thank you for the reply Flynfrog.

Can you just clear this up a little bit, I did not understand you:

You can try off setting a surface then batching the gap around the outside to get a solid as well. Nice work.

you can off set a surface in SW then fill in the gap between the two with another surface. once these are stitched together I think it will give you an option to make them solid. Its been a while since I've done it ill try to post some shots when I get home.

[george85]

anyhelp on your last reply, please flynfrog

You can try off setting a surface then batching the gap around the outside to get a solid as well. Nice work.

[flynfrog]

https://forum.solidworks.com/thread/16801

in better words than I have