FIA Sporting Regulations - 19.1
b) Each Competitor must provide a summary document to the Media Delegate listing the name and brief description of all major aerodynamic and bodywork components and assemblies that have not been run at a previous Competition or TCC and are intended to be run at the Competition (requirements and format as defined by the Media Delegate, in conjunction with the Commercial Rights Holder). This summary document must be provided no later than twenty-three (23) hours prior to the scheduled start of P1.
i) The contents of this document will remain with the FIA and the Commercial Rights Holder and will not be provided to the media until the start of the pre- event car display.
FIA Technical Regulations
ARTICLE 3: AERODYNAMIC COMPONENTS
3.1 Definitions
3.1.1 Aerodynamic Components or Bodywork
All parts of the car in contact with the external air stream.
a. The following components are considered to be bodywork:
i. all components described in Article 3;
ii. inlet or outlet ducts for the purpose of cooling, up to the component they are intended to provide cooling for;
iii. inlet ducts for the power unit (air boxes) up to the air filter;
iv. primary heat exchangers, as defined in Article 7.4.1 (b).
b. The following components are not considered to be bodywork:
i. cameras and camera housings, as defined in Article 8.17;
ii. rear view mirrors as defined in Article 14.2;
iii. the ERS status light;
iv. parts definitely associated with the mechanical functioning of the power train, transmission of power to the wheels, and the steering system providing, in any case, none are of a design contrived to achieve an aerodynamic effect;
iv. the wheel rims and tyres;
v. the brake disc assemblies, calipers and pads.
All components described in Article 3
ARTICLE 3: AERODYNAMIC COMPONENTS
3.1 Definitions
3.2 General Principles and Legality Checking
3.3 Component Definition
3.4 Overall Dimensions
3.5 Floor
3.6 Front Bodywork
3.7 Rear Bodywork
3.8 Tail and Exhaust Tailpipe
3.9 Front Wing (FW)
3.10 Rear Wing
3.11 Final Assembly
3.12 Bodywork not defined in Articles 3.5 to 3.11
3.13 Wheel bodywork
3.14 Suspension Fairings
3.15 Aerodynamic Component Flexibility
3.16 Aerodynamic Component construction