Nice work!bar555 wrote:my analysis on F150
http://formula1techandart.wordpress.com ... -the-past/
My benighted employer's IT trolls don't allow me to see the site linked to (I think the "technical" in F1technical.net fools them), but I WILL check it from home. bar555, your posts are always very valuable. Thanks!bar555 wrote:my analysis on F150
http://formula1techandart.wordpress.com ... -the-past/
n smikle wrote:I captured it from this video:
[youtube]http://www.youtube.com/watch?v=H1Jw9W3C ... r_embedded[/youtube]
All good points.Just_a_fan wrote:An upward flexing floor does't help in the way that the bib did because it's already 60mm above the ground and can't get any nearer than that - unless the stays allow it to flex downwards.forty-two wrote:Granted, but a cable stay only normally works in tension, so I suspect that there might be scope for the floor to flex upwards, but not perhaps downwards. While I agree that allowing the floor to move closer to the floor might be beneficial, I can think of a couple of wierd ways in which allowing it to move upwards might help. For example, remember the bendy bib of the RB6 which allowed them to get away with running super low without wearing the plank, well what if Ferrari have found a similar trick?Just_a_fan wrote: The idea was that the stays might alow downward flex at speed which would place the floor nearer the ground. The nearer the ground the better it works.
Unless of course the Scuderia have developed elasticated steel cable. If so, I want some!
And all steel cables are elasticated if you can pull hard enough on them...
1: Marketing reasons.forty-two wrote:A couple of things just occurred to me:
1. Aside from publicity (granted this is a big one!) why would Ferrari show their cards so early
2. Why not show the new FW, is it something very special, or is it just not ready?
3. With this car being apparently so similar to the F10, what aces have they got up their sleeves?
Ok, it was three and not a couple, but still!