The FOZ wrote:I may have confused you by misusing "chassis" in my previous post. I was referring to the survival cell (tub) only.bot6 wrote:I very much doubt that they are using the W01 chassis, since it would be non-compliant with the new weight distribution requirements. Also, the car would show its old roll blade. And they would have to fit the KERS in somehow.
This test car is definitely a new chassis. Might not be the final racing version of the new chassis, but it's definitely more W02 than W01.
What we know for sure is we will see a new exhaust layout and a new front wing on the W02 come the next test. These updates were announced by Brawn. This will probably come with at least a slight modification of the diffuser and floor, since the exhaust will not blow on them in the same way.
As for the other parts of the car (airbox and sidepods mainly), we won't know before the 8th.
I'll restate:
They could be using the survival cell from the W01 (homologated in 2010) with updated bodywork, nose, suspension, and wings. I don't know of any rule prohibiting this.
The weight distribution isn't a problem using the W01 survival cell - the final weight of the car (obviously) is determined by the entire group of components - and if needed, teams can add ballast as needed, so long as the car doesn't go below 291kg (front) and 340 kg (rear). Further, the weight distro rules (and most technical regs, in fact) only apply to practice, races and qualifying. Preseason testing and in-season testing are not covered in many cases.
The advantage to delaying the homologation of a survival cell is that it allows the team the maximum amount of time to make changes to the survival cell design based on any new concepts they saw other teams running. The case of the F-duct was a good example - many teams lagged or were unable to incorporate the ducting to their cars because they couldn't alter the survival cell design once it was homologated. In that case, I'd certainly send a few bogus tubs for crash testing that I know would fail, as a rumor of difficulties in crash tests would nicely cover up my actual intentions...
Looking strictly at the tub, I've seen nothing that suggest the car being run so far this isn't a W01 tub with different bodywork and wings, and we wouldn't likely know this unless someone from the team actually admitted it.
I'll alter my prediction a bit, though. Whichever tub they're running, whichever roll structure they're running, there's nothing stopping them from adding dummy bodywork to conceal the true geometry - which might be the reason for the very rough looking air intake/roll hoop area. I'll venture that they've got a 2011-legal blade roll structure hiding under some bondo.
+1
It is entirely feasible that they are using a modified W01 Tub since there is a lot of similarity. Look at how the lower wishbones meets the bottom of the tub. Nearly identical...
We need to get some definitions clear on this forum.
The Safety cell is the bit the driver sits in.
The Chassis comprises the Safety cell, the floor and the suspension.
We have been using the word Chassis to often to describe the Safety Cell and I think I've been guilty of it in past posts too.