They could change the exhaust housing angle by 1 degree. But that's not what's happening. The left rear tire is like that because this track is super left side dependent. That is additional shear load from high G turning on left high speed sweepers. As you can see the right rear doesn't have the same inside degradation that would indicate the exhaust burning away the tiremurtoidf1 wrote:lets assume the tyres are degrading due to exhaust flow, what could they do to combat it?
Very good point, unsprung weight would be a primary objective.Crash Bandicoot wrote:Isn't this just a weight thing? Doesn't a simple nut and thread just give you much less unsprung weight than a hydraulic system?
My non-technical brain would suggest that some sort of interlocking teeth on the wheel and hub (not sure if that's the right description) would solve this...KeiKo403 wrote:Also with the threaded nut you can torque it up that means you'll effectivly lock the wheel into position onto the hub. I guess if you use a push fit coupling device then when the brakes are applied what makes the wheel actually stop spinning and the same under acceleration?
Actually, bear with me hear....lets stick to the round peg and round hole scenario. Could there be some kind of electromagnetic coupling between the hub and the wheel?KeiKo403 wrote:Also with the threaded nut you can torque it up that means you'll effectivly lock the wheel into position onto the hub. I guess if you use a push fit coupling device then when the brakes are applied what makes the wheel actually stop spinning and the same under acceleration?
EDIT: However this is only an issue with a 'round peg in a round hole' If the end of the hub is square or even octaganle and the hole in the centre of the wheel is the same shape then maybe we could be onto something here.
The more i think about this the retaining device could be built into the wheels some how so that pit crews push the wheel on and it is locked into place straight away....Don't know, we could be flogging a dead horse here, so to speak!
Yes, seems to be a lot of stuff taped to the beam wing.Pup wrote:Tire wear on the rears is looking really nice and even, yes?
The hub has drive teeth that engage with suitable indentations on the wheel's inner face. The nut is just there to stop the wheel moving outwards on the half shaft.KeiKo403 wrote:Also with the threaded nut you can torque it up that means you'll effectivly lock the wheel into position onto the hub. I guess if you use a push fit coupling device then when the brakes are applied what makes the wheel actually stop spinning and the same under acceleration?
A hole for stuff....Usually testing equipment.Jef Patat wrote:What could that tiny hole, where the sidepod meets the floor, be?