lol you work for them or something the tires have been failing for years now and on this race both tires failed at the side wall not the running surface how can debris cut the side wall please explainringo wrote: ↑15 Jun 2021, 03:45The tyres are strong enough. If they get cut repeatedly by debris, its hard to guarantee integrity of the structure.
And the thing about the tyres failing in the same spot. That is very likely. The debris can be picked up anywhere arounf that track, any sector, and get cut up. But the straight is where the load increases from downforce but also the speed of rotation and thus they hoop stresses as PZ said. That high stress part is in fact the main and first place where any tyre failure with happen. Kinda like a plane landing. The highest stressed are going to be seen on landind and not take off.
I suspect debris was the issue. The tyre could infact have encountered debris laps before the failure.
What do you propose would be a better one stop tyre?
For me i would like 2 options a 1 stopper or a 2 stopper where the tires make up the advantage for the extra stop.PlatinumZealot wrote: ↑15 Jun 2021, 19:12What do you propose would be a better one stop tyre?
Remember the "cliff" in 2011?
These current Pirellies degrade gradually and predictably once you manage the temperature. The problem is they have to be babied to keep them going.
They are quite sticky however. The fastest tyres in the world currently.
You might want a design that doesnt have to be babied but all the teams will easily master it and the tyre life would be crazy long. Its a balance really.
I howver dont blame tyres. I blame the fact that a pitstop is too punishing. I have a thread where i proposed that refuelling will remove the penalty of a pitstop.
Sure sounds like a design failure by the Pirelli engineering department to me...“The process established that there was no production or quality defect on any of the tyres; nor was there any sign of fatigue or delamination. The causes of the two left-rear tyre failures on the Aston Martin and Red Bull cars have been clearly identified. In each case, this was down to a circumferential break on the inner sidewall, which can be related to the running conditions of the tyre, in spite of the prescribed starting parameters (minimum pressure and maximum blanket temperature) having been followed.”
And this reads like, since we screwed up (Again), we are going to make the teams jump through even more hoops!The statement added: “As a result of this analysis, Pirelli have submitted their report to the FIA and the Teams. The FIA and Pirelli have agreed a new set of the protocols, including an upgraded technical directive already distributed, for monitoring operating conditions during a race weekend and they will consider any other appropriate actions.”
Running conditions of the tyre? Hmm. Very interesting.
Indeed, this could be crucial for the title fight...
Tire blanket temperatures are maximized, aren't they? (80deg rear, 100 front as far as I know).PlatinumZealot wrote: ↑16 Jun 2021, 05:10Running conditions of the tyre? Hmm. Very interesting.
For years now there is a suspiscion that RedBull ( as well as two other teams) has wheels that lower the tyre pressures.
They also have agressive heating methods.
I can see the tyres getting crystalized with high side-wall flex and high sidewall temperatures. Possibly even a hydrocarbon liquid is being released into the tyre to refridgerate it. That in itself could have dissolved the rubber a bit and contributed to the break. RedBull has so many tricks I dont even know where to start speculating.
Awaiting further reveals.